• Home  / 
  • Shed Plans
  •  /  Shed Making Guide: How to Make & Install a Shed Door

Shed Making Guide: How to Make & Install a Shed Door

Buying a Shed vs. Building a Shed
Spread the love

It’s not enough to throw a tarp over your gardening and swimming gear to protect it from the harsh sunlight, heavy rains, and seasonal snowfall. Taking proper care of your equipment requires you to build a shed to keep them safe from environmental damage.

Starting a DIY shed project

Although you may have bought a premade shed in the hardware store, taking on a DIY project may be best because you can build it to your requirements. In this article, we will share a four-step guide on how to make a shed door for your storage needs:

1. Set your door’s dimensions

The width of your shed door should be at least three feet long to allow easy access in bringing different types of equipment in and out. If you are keeping a riding lawnmower, for example, you should make adjustments that can range from five to six feet with your width.

Remember that the larger your shed doors are, the more complex your project will be. Regardless of your door’s width, you should extend it up to the top of your wall frame to provide you with more headroom while simplifying the framing process.

2. Consider the roof load

Before you start looking for the placement of your door, you should consider the shed’s roof load. Your shed’s entrance frame requires a durable header to distribute the weight of the roof down to the opening’s sides.

A triangular roof, or a gable roof, will mean that it is supported by two sidewalls that are parallel to its ridge line with the end walls experiencing no significant load. However, if you have rafters bearing on all four walls, you should have a hip roof installed, which means that both sidewalls and end walls support the roof’s weight.

3. Add studs to support your shed

Once you’ve decided where to place your entrance, you need to make the right markings to fit your door’s dimensions. At the center point of your wall, measure the half of the entrance’s width to each side of the center point; these two edges will be your entrance’s opening.

Install an additional stud at each location with its edges being 1.5 inches away from your previous markings for the installation of jack studs for later. These two studs will support your double doors or function as a doorstop for a single door.

4. Install your shed’s header

A single two-by-four can function as a stable header if you have a gable roof with your entrance at an end wall. However, if your entrance is on a side wall with a hip roof, you’ll need a more durable header that can distribute the roof’s load.

Keep in mind that the nails holding your header in place might not be enough to support your roof’s load. This is where you can use jack studs to transfer the header’s weight by cutting two studs long enough to extend from the header to the floor. Nail the studs to the door studs so that it’s directly holding up the header’s weight.


Building a shed will require lots of time and effort, whether you’re making it from the ground up or repurposing an older structure. The key to making sure that your DIY project goes smoothly is by making a proper analysis of the materials you’ll use and double-checking your measurements to avoid wasting lumber.

Shed Mechanics is an informative source for everything about shed building, from finding the right materials to setting up the right shed foundation. Visit My Shed Plans to get the latest tips for DIY wood shed plans on the newest shed models and builds!